SRST with COR

Posted: April 2, 2006 by sankar in Cisco General

Restricting outbound calling with COR lists while in SRST mode.

 dial-peer cor custom           #### define COR list member

name LD

name Local

name 911

dial-peer cor list Site2            #### allow 911, LD and Local for Site 2 phones

member 911

member LD

member Local

dial-peer cor list outgoingList           

member 911

member LD

member Local

dial-peer cor list Site3  ### do not allow any outbound calling on Site 3 phones. This list is a subset of outgoing. So calls will be denied.

member 911

dial-peer voice 1 pots

port 1/0/0

cor outgoing outgoingList

call-manager-fallback

cor incoming site2 1 4000 – 4010 ### — site 2 list is applied to site 2 phones. Specify range.

cor incoming site3 2 5000 – 5010  ###—- site 3 list is applied to site 3 phones. Specify range.

 Outcome:

Any number in the 4xxx range should be able to call outbound.

Any number in the 5xxx range is denied outbound access.

Advertisements
Comments
  1. Shibin says:

    Can we use COR list to control the ports used for making outbound calls based on the calling number ?Basically we have a ewquirement to route outbound calls only through specific set of PRI’s based on the calling number.Is it possible during SRST?

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s