VG248 Call Control Modes

Posted: May 23, 2006 by sankar in Analog, Fax

a. standard – no need to use feature codes…features available are similar to feature mode.
b. feature – use feature codes for transfer and conference and other phone features. Use hookflash and feature code at the end to perform the operation (xfer, conf etc). With feature mode, there is independent control of each call leg.
c. basic – no transfer/conf. good for fax and modems
d. restricted  – most limited call mode. Used with billing system that begins charging when calls connect.

To change call control mode, go to each port, port specific parameters and enable the mode. default is standard.


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s