How to network Callmanager to CME using two Gatekeepers and H323 Proxy.

Posted: June 11, 2006 by sankar in Gatekeeper

Coming soon……..

Advertisements
Comments
  1. dinnu says:

    By any chance did you get this setup working ? I am trying for past couple of days to simulate this scenario without any success.

    h323proxy–registered–GK1
    CCM–registered–GK1
    CME– registered –GK2

    when i configure “use-proxy” on GK1 for any outbounds calls from CCM to CME , gatekeeper is trying to use h323 proxy , but then call fails .. couldn’t figure what else needs to be configured on h323 proxy GW inaddition to the following commands

    h323-proxy GW
    ——————
    interface Loopback0
    ip address 192.168.111.1 255.255.255.0
    h323 interface
    h323 h323-id PROXY
    h323 gatekeeper ipaddr 192.168.10.3 <– GK IPaddr
    h323 t120 bypass
    h323-gateway voip interface
    end

    GK
    ——

    do we need to configure any dial-peers on the h323 proxy ? I could’t get hold of any cisco document that has a configuration example on using h323 proxy with gatekeeper..

    use-proxy CCM remote-zone CCME inbound-to gateway
    use-proxy CCM remote-zone CCME outbound-from gateway

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s